CED Training

Training: MFG213: Industrial Electrical Controls Fundamentals

Date: February 5, 2019 - February 8, 2019
Location: CED Omaha | 9201 J Street
Cost: $2,210
Description

This course provides students with the knowledge and skills required to install, maintain and troubleshoot machine controls. At the completion of this course, students will be able to: define the safety considerations that must be observed when installing, checking, or locking out electrical equipment; define uses and functions of input and output devices, relays, and motors; demonstrate the reading of schematic diagrams and logic; define an open and short condition and perform voltage and current measurements; demonstrate the proper use of the following test equipment in lab to measure voltage, current, resistance and continuity: VOM, DVM, Multi-meters, continuity tester, and amp probe; approximate secondary voltage, secondary current, and primary current of a transformer when given its turns ratio, primary voltage and secondary load; identify the proper wiring configurations of a control transformer’s primary current for 240V and 480V operation; and approximate a transformer’s maximum primary current for 480V operation, using the nameplate information. For more information click here.

Register